ec centrifugal fans backward curved, single inlet, ? 560 highlights: C 9-blade fan, 3-phase fan motor C 10 vdc max. output / 10 ma, 20 vdc max. output / 50 ma, 0-10 v slave output, 24 v external program input, 0-10 vdc / pwm control input, 0-10 v or 4-20 ma sensor input, external release input C integrated pid controller, control interface with selv potential safely disconnected from the mains, rs485 modbus rtu technology C over-temperature protected electronics / motor, operation and alarm display, alarm relay C soft start, pfc passive, line undervoltage / phase failure detection material: impeller: aluminum sheet rotor: coated in black electronic housing: die-cast aluminum assembly: galvanized steel with aluminum posts mounting position: shaft horizontal or rotor on bottom; rotor on top on request condensate discharge holes: rotor-side (1) nominal data at maximum load. measurement: lu-118570 measurement: lu-120955 measurement: lu-120956 measurement: lu-120957 air performance measured as per: iso 5801, installation category a, without protection against accidental contact. suction-side noise levels: l w a as per iso 13347, l p a measured at 1m distance to fan axis. the values given are valid under the measuring conditions mentioned and may vary accoring to the actual installation situation. with any deviation to the standard set-up, the specifc values have to be checked and reviewed once installed or ftted. for detailed information on the measuring set-up, please contact ebm-papst. curves n rpm p e w i a (460v) i a (230v) l w a in db(a) nominal data air fow nominal voltage range frequency power input (1) speed (1) current draw (1) temperature range (1) mass i ngress protection rating electrical wiring diagram ul type radipac motor cfm vac hz watts rpm a c lbs R3G560-AH29-66F eg1r-240-560-30 m3g150-if 7,775 200...240 50/60 3,000 1,520 8.5 -25...45 65 ip54 a yes r3g560-ah23-65f eg1r-480-560-30 m3g150-if 7,775 380...480 50/60 3,000 1,520 4.0 -25...60 65 ip54 a yes 0 2.000 4.000 6.000 8.000 cfm 0 0.2 0.4 0.6 0.8 1 1.2 1.4 1.6 1.8 2 2.2 2.4 2.6 2.8 3 3.2 3.4 3.6 3.8 in. wg 2.000 4.000 6.000 8.000 10.000 12.000 14.000 16.000 m 3 /h pfs[pa] pfs[pa] 2.000 4.000 6.000 8.000 10.000 12.000 14.000 m 3 /h 950 900 850 800 750 700 650 600 550 500 450 400 350 300 250 200 150 100 50 pfs[pa] 1 2 3 4 5 6 7 8 9 10 11 12 a a a a a a a a a a a a 13 14 15 16 a a a a 1 2 3 4 5 6 7 8 9 10 11 12 a a a a a a a a a a a a 13 14 15 16 a a a a 1520 2029 2.7 5.8 87 1520 2636 3.5 7.8 84 1520 3000 4.0 8.5 82 1520 2981 4.0 8.0 83 1260 1156 1.6 3.3 81 1260 1519 2.0 4.4 79 1260 1730 2.3 4.9 78 1260 1619 2.2 4.6 78 1000 617 0.9 1.6 75 1000 799 1.1 2.2 73 1000 908 1.2 2.4 72 1000 839 1.2 2.2 73 760 302 0.5 0.7 68 760 378 0.6 1.0 69 760 423 0.6 1.0 67 760 392 0.6 1.0 67
eg1r-xxx-560-30 ?22.24 ( 565 ) ?15.67 ( 398 + 1.5) depth of screw max. 25mm cable diameter: min. 4 mm, max. 10 mm; tightening torque: 4 + 0.6 nm accessory part: inlet nozzle 63071-2-4013 not included in the standard scope of delivery. tightening torque 3.5 + 0.5 nm ?9.13 ( 232 - 2 ) ?10.83 ( 275 ) ?9.92 ( 252 + 0.3 ) 7.68 ( 195 ) 10.16 ( 258 ) .20 ( 5 ) 10.79 ( 274 + 2 ) 13.54 ( 344 + 3 ) 2.76 ( 70 ) 3.23 ( 82 ) .08 ( 2 ) ?15.16 ( 385 ) ?14.96 ( 380 ) ?20.28 ( 515 ) ?19.29 ( 490 ) ( ) ?.24(6) (6x) r3g560-ahxx-xxf 15.394(391) 22.047 ( 560) 29.528 ( 750 ) ? .433 ( 11 ) 8 places 13.622(346) 31.496 ( 800) dimensions shown in inches (mm) dimensions shown in inches (mm)
|
